Lenze 9400 Manuale Utente Scaricare il pdf (Pagina 296)

9 "CAN on board" system bus

9.2 Possible settings by DIP switch

296

Lenze · Servo-Inverter 9400 HighLine · Reference manual · DMS 10.0 EN · 11/2013 · TD05/06

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

9.2 Possible settings by DIP switch

The DIP switches on the front of the memory serve to set the baud rate and the node address.

[9-1] DIP switch

9.2.1 Setting the node address

The node address can be set via code C00350 or with the DIP switches 1 to 64.

• The labelling on the housing corresponds to the values of the individual DIP switches for

determining the node address.

• Valid address range: 1 … 127

Example: Setting of the node address 23

 Tip!

The node address resulting from the setting of the DIP switches at the last mains switching

is displayed in C00349/1

.

Baud

CAN Address

O

N

cdba

64

32

16 8

421

 Note!

• The addresses of the nodes must differ from each other.

•All

twelve DIP switches = OFF (Lenze setting):

• At switching on, the settings under code C00350

(node address) and C00351 (baud

rate) will become active.

• Switch the voltage supply of the basic device off and then on again to activate altered

settings.

DIP switch 64 32 16 8 4 2 1

Switch position OFF OFF ON OFF ON ON ON

Value 0 0

16 0 4 2 1

Node address = Sum of the values = 16 + 4 + 2 + 1 = 23

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 953 954

Commenti su questo manuale

Nessun commento